Showing posts with label hat. Show all posts
Showing posts with label hat. Show all posts

Tuesday, November 15, 2011

Tutorial: Devil's advocate Hat

Sewing Tutorial: Knotted Baby Hat



This is a tutorial I did as a guest post on Bear Rabbit Bear last month. Just republishing it her in case you'd missed it earlier.

Devil's advocate baby hat:

Supplies

    * Knit fabrics: Take 2 pieces of same fabric or two different fabrics – use up those scraps that are too big to throw away but too irregular to make into a dress, top etc.

    * Print out the pattern [PDF page 1 and page 2], tape the two pages as shown and cut out both pieces of the pattern (total of 3 cuts – piece 1 spans both pages and piece 2 is on page 1. Once you cut out all the three pieces, tape both parts of Piece 1 by overlapping the small part over the bigger part, up to the line on page 2.

   1. Fold each fabric in two layers, then fold one more time. Place each pattern piece on fold and cut. So now you have two pieces of #1 and two pieces of #2.

Note: Just Ignore the joint in the center...its there because I didn't have enough fabric, but if you cut the patterns on the fold, you shouldn't have it.
2.  Sew together pieces of #1 along the cone, bunny ears side, leaving just the bottom straight side raw, right sides together. Sew together pieces of #2 along the semi-circular side, right sides together.

This is the place where my camera died and I couldn't take pics of the rest of the process, so I continued
with another hat next day.

   3. Now join #1 and #2 by sewing along the raw edge, right sides together. Leave about 2 inch opening.

   4. Using the opening, turn the whole thing inside out. Use a pencil or point turner to poke the ears out on fabric #1. Push the fabric #2 inside fabric #1.
   5. Slip-stitch the opening shut.

   6. Tie two knots with the 'ears' of Fabric #1. You may have to adjust these knots a bit to give them the right look. The knots also give you some control over the size of the hat so you can make it fit the child's head a little better.

If the hat is a little big, you can turn some of the bottom out to fit the head of the baby. The best part is that these hats don’t have a any inside seams to bother the baby skin. Enjoy your little devil's advocate...he'll soon be coming up with some tough questions.

Tuesday, October 4, 2011

Devil's advocate Baby Hat tutorial: Guest posting at Bear Rabbit Bear

How to sew knotted baby hat
knotted baby hat sewing tutorial



Just popped in to say that I'm over at Bear Rabbit Bear today, Guest posting my tutorial for Devil's advocate Baby Hat. Hop on over and check out this tutorial as well as other cool tutorials Melanie's guests are sharing for Fall Project Week.





Pin It

Wednesday, September 14, 2011

Knotted baby hat tutorial

Sewing for baby: Knotted hat tutorial
I did this guest post over at Whip Up a few weeks ago. Since then, I have modified the pattern a bit, so the final product looks more finished. Posting it here in case you missed it over at Whip Up and also adding the revised steps (in blue).



With the birth of my niece last month, newborn gifts are on my mind these days...Here's a tutorial for making a knotted hat for newborns. I love making and gifting these hats....because they are useful and practical?....naah...because seriously, what's cuter than a teeny-tiny hat on a teeny tiny head. The fact that hats are particularly pricey and difficult to find in ready-to-wear clothes doesn't hurt either. So without further ado...here's how to make one:

Supplies:

Knit fabrics: Take 2 pieces of same fabric or two different fabric. 

This is a great project to use up those scraps that are too big to throw away but too irregular to make into a dress, top etc.

1. Print out the pattern, tape the two pages as shown and cut both pieces of pattern ( total 3 cuts). Piece 1 spans both the pages whereas Piece 2 is only on Page 1.
Once you cut out all the three pieces, tape both parts of Piece 1 by overlapping the small part over the bigger part, up to the dash (-) mark.


2. 

Fold each fabric in two layers, then fold one more time. Place each pattern piece on fold and cut. So now you have two pieces of 1 and two pieces of 2.

3.

 Sew together pieces of 1 along the conical side, right sides together. Sew together pieces of 2 along the semi-circular side, right sides together. 

Note: Leave  a 2 inch opening while sewing piece 2 ( lining). This is an improvement from earlier version where I leave the opening at the joining seam in step 4.

4. 

Now join 1 and 2 by sewing along the raw edge, right sides together. Leave about 2 inch opening.
Note: It was only after sewing a couple of these hats, that I realized I should have left the opening in inner lining piece instead of the seam joining the two pieces. It was one of those "Duh...I'm so stupid" moment.

5. 

Using the opening, turn the whole thing inside out. Use a pencil or point turner to poke the cone out on fabric 1. 
Note: Slip-stitch the opening in fabric 2 shut. I missed this step when I wrote the guest post. 

Push the fabric 2 inside fabric 1. 

6.

Tie a knot with the cone of fabric 1. 
If the hat is a little big, you can turn some of the bottom out to fit the head of the baby. The best part is that these hats don't have a any inside seams to bother the baby skin. Enjoy your little munchkin...hats and all.

Tuesday, June 14, 2011

Reversible Sun Hat

Reversible Sun Hat sewing project

reversible sun hat sewing
Based on pattern Sprinkle's Sun Hat From Valerie Van Sharder's book "Sweet Booties". This pattern didn't really work out for me. For one thing I chose the Newborn size because everything else seem to fit my 18 mos old in that size :o . Apparently little one actually has the head of an 18 month old even though the rest of her body is newborn size. No idea if the sizing is off in the book or its my little one.

sewing a reversible sun hat
Also the pieces didn't line up properly for me. Again, it could just be my cutting skills ( or lack of them ).
Since I have already returned the book, I'll try to self modify the pattern. Hats are a very cute and functional accessory, so it will be good if I have a go to pattern for these.

Monday, May 9, 2011

Quick Fix: Hat Redo

Fix a hat DIY
With the spring being in full swing in this corner of the world we have been spending a lot of time outside, playing with the dirt in the backyard or taking long walks outside, and we all know how rough the sun can be on skin. I had a sun hat which I wanted to use, but it has an awful trim and I just didn't love it, but I needed a hat badly. So here's how I fixed the problem:

Before:

hat before changes

After:


hat after changes
Do you have something that could use a quick fix?